제품소개
QUICK 메뉴
greetings
products
technology
home > Products > CCD Module > FPC Bonder
FPC Bonder - CARRIER에 적재된 CAMERA MODULE은 순차적으로 ACF BONDING하여 PRE BONDER 작업 ZONE으로 이동하고, 역시 CARRIER를 통해 공급된 FPC는 PRE BONDER가 직접 PICKUP한 후 작업 ZONE에서 CAMERA MODULE과 각각 동시 VISION ALIGN하여 PRE BONDING하고 이후 FINAL BONDER로 열 압착 후 UNLOADING하는 장비이다.
설비 레이아웃 보기
설비spec
Outline The camera module placed in the carrier is bonded with ACF in sequence and is fed to Pre-bonder zone. The FPC transferred also by a carrier is picked up
by Pre-bonder and bonded (pre) after simultaneous vision alignment along with camera module in the work zone. FPC is then unloaded after the heat pressing in the final bonder.
Tact Time 6.3sec / 1module
- ACF bonding time : 2s
- Pre bonding time : 0.3s
- Final Bonding time : 18s (Simultaneous working on all four heads)
- Module size 10*10mm or less
- FPC size 15*35mm or less
BONDING
Accuracy
ACF X : ± 0.3mm
Y : ± 0.15mm
Bonding X : ± 100㎛
Y : ± 100㎛
Bonding method Cartridge heater + Cylinder air pressure
Camera module carrier To be mounted in the Magazine (10ea carrier / 1 Magazine)
FPC carrier * at customer's requirement
Camera
module
carrier
Height 5mm~7mm * at customer's requirement
Length 6.5mm~11mm
Width 6.5mm~11mm
FPC size Length 7mm~15mm
Width 7mm~35mm
Utility Power 3Phase 220V 50/60Hz
Air 5~8Kgf/㎠ 500L/min
Vaccum Lower than ㅡ70Kpa
Equipment size 2450(L)*1500(W)*1760(H) TOWER LAMP excluded
 
copyright(c) astjetec co.ltd.all rights reserver. ASTJETEC Copyright